Cloudera Enterprise 6.0.x | Other versions

Configure Network Names

  Important: CDH requires IPv4. IPv6 is not supported.
  Tip: When bonding, use the bond0 IP address as it represents all aggregated links.

Configure each host in the cluster as follows to ensure that all members can communicate with each other:

  1. Set the hostname to a unique name (not localhost).
    sudo hostnamectl set-hostname foo-1.example.com
  2. Edit /etc/hosts with the IP address and fully qualified domain name (FQDN) of each host in the cluster. You can add the unqualified name as well.
    1.1.1.1  foo-1.example.com  foo-1
    2.2.2.2  foo-2.example.com  foo-2
    3.3.3.3  foo-3.example.com  foo-3
    4.4.4.4  foo-4.example.com  foo-4
      Important:
    • The canonical name of each host in /etc/hosts must be the FQDN (for example myhost-1.example.com), not the unqualified hostname (for example myhost-1). The canonical name is the first entry after the IP address.
    • Do not use aliases, either in /etc/hosts or in configuring DNS.
  3. Edit /etc/sysconfig/network with the FQDN of this host only:
    HOSTNAME=foo-1.example.com
  4. Verify that each host consistently identifies to the network:
    1. Run uname -a and check that the hostname matches the output of the hostname command.
    2. Run /sbin/ifconfig and note the value of inet addr in the eth0 (or bond0) entry, for example:
      eth0      Link encap:Ethernet  HWaddr 00:0C:29:A4:E8:97  
                inet addr:172.29.82.176  Bcast:172.29.87.255  Mask:255.255.248.0
      ...
    3. Run host -v -t A $(hostname) and verify that the output matches the hostname command.

      The IP address should be the same as reported by ifconfig for eth0 (or bond0):

      Trying "foo-1.example.com"
      ...
      ;; ANSWER SECTION:
      foo-1.example.com. 60 IN        A       172.29.82.176
Page generated July 25, 2018.